Mark the bolt hole positions with a black fine tip marker. Pull the wing off and drill the holes. We recommend double checking each hole after you drill them by placing the wing back in place to make sure the holes line up. 
|
Place the wing back in place and put the bolts thru the holes. In our case, the holes where snug enough to hold the bolts in place for the next step. Open the trunk lid. It's usually a good idea to have a friend hold the hood while you pop it. Carbon fiber lids weigh far less than stock ones so it will pop with some force. We don't want to damage the lid since our nuts are not on yet. Put the nuts on the end of the bolts and hand tighten. Then tighten them with a wrench. Be careful to not tighten too much or you might crack the carbon fiber. 
|
