 7. Once all areas are tacked up you will then need to grind down the welds making a smooth surface. If holes start to show after grinding make sure to tack them up and grind smooth again until you are satisfied with the work. 
|
8. Once we were satisfied with the grinds, we then sanded down the trunk areas where the spot putty would go. 9. Once sanded down, a layer of spot putty was layed down to help get rid of low spots in the work and smoothing everything out. 10. After the putty has time to cure, it was then sanded down until happy with the curve with the rest of the trunk area.
|
