 | A custom floor board was needed along with tubbing the rear. |
  | To take care of the seating arrangements, Integra bucket seats where used front and rear and wrapped in sand tweed & vinyl. |
Finally to complete this show stopper, the frame and engine compartment needed a little love. Matt started by pulling the 4.3 out and cleaning and smoothing the frame, then it was sprayed silver.
|
 Next, the firewall was smoothed and painted. The factory 4.3 was cleaned and painted green and silver.  In addition, Taylor plug wires, Edelbrock headers and a K&N filter was added. To bring it all together, a Flexalite dual 12 inch electric fan was added. To get the deep throat sound, Matt decided to go with a 3” Dynomax muffler and the exhaust was applied with a Ceramic finish. The engine wiring harness was also modified to clean up the engine.
|
